Without Scan Tool

Without using SST (NGS tester)

Caution: Connecting the wrong DLC terminal may possibly cause a malfunction. Carefully connect the specified terminal only.





1. Connect the TBS terminal at the D1 around using a jumper wire.
2. Turn the ignition key to ON (engine OFF).
3. Output all memorized DTCs.
4. After verifying that the first code is repeated, depress the brake pedal 10 times or more at intervals of less than 1 seconds.
5. Turn the ignition key to OFF and disconnect the jumper wire.

Note:
^ DTCs cannot be cleared if the following occur:
- If intervals of depressing the brake pedal exceed 1 seconds.
- The brake switch has failed.