Side Protector NO1. NO2. NO3

REMOVAL

1. Pry the side protector end 20 - 30 mm {0.79 - 1.18 in} by using a flathead screwdriver or a razor knife.
2. Pull the side protector forward to remove it.

NOTE: The side protector is installed with double-sided adhesive tape. If the side protector is difficult to remove, soften the double-sided adhesive tape by using a hot air blower.

INSTALLATION

1. Remove the adhesive remaining on the side protector (if it will be reused) and the body by using a razor knife.
2. Remove any grease or dirt from the adhesion surface of the side protector (if it will be reused) and body.




3. Attach double-sided adhesive tape to the side protector as shown (if it will be reused.).




4. Peel off the wax paper from the double-sided adhesive tape and attach the side protector onto the body as shown.