Trunk / Liftgate Latch Release Cable: Service and Repair

TRUNK LID LOCK AND OPENER REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Open the trunk lid.
3. Remove the rear finisher.




4. Remove in the order as indicated below.
1. Fastener
2. Screw
3. Trunk lid lock cover
4. Bolt A
5. Connector A
6. Trunk lid lock
7. Internal Trunk Lid Release Handle
8. Bolt B
9. Connector B
10. Trunk key cylinder

5. Install in the reverse order of removal.

Internal Trunk Lid Release Handle Installation Note

CAUTION: Always keep the handle firmly attached to the holder and in the recessed position. Not securing the handle this way could allow it to snag luggage in the compartment and open the trunk lid.

1. After installation of the internal trunk lid release handle, pull the handle forward to verify the handle and rod are securely installed.




2. Attach the handle to the holder on the cover and in the recessed position.