Fuel Injector Resistance Test
Resistance InspectionNOTE: Perform the following test only when directed.
1. Disconnect the fuel injector connectors.
2. Measure the resistance of the fuel injector using an ohmmeter.
- If as specified but On-vehicle Inspection is failed, carry out the "Circuit Open/Short Inspection".
- If not as specified, replace the fuel injector.
Resistance
12 - 16 Ohms [20 °C {68 °F}]
Circuit Open/Short Inspection
Open circuit
- Ground circuit (No.1 cylinder fuel injector connector terminal B and PCM connector terminal 3W)
- Ground circuit (No.2 cylinder fuel injector connector terminal B and PCM connector terminal 3X)
- Ground circuit (No.3 cylinder fuel injector connector terminal B and PCM connector terminal 3Y)
- Ground circuit (No.4 cylinder fuel injector connector terminal B and PCM connector terminal 3z)
- Power circuit (No.1 cylinder fuel injector connector terminal A and main relay connector terminal D through common connector)
- Power circuit (No.2 cylinder fuel injector connector terminal A and main relay connector terminal D through common connector)
- Power circuit (No.3 cylinder fuel injector connector terminal A and main relay connector terminal D through common connector)
- Power circuit (No.4 cylinder fuel injector connector terminal A and main relay connector terminal D through common connector)
Short circuit
- No.1 cylinder fuel injector connector terminal B and PCM connector terminal 3W to ground
- No.2 cylinder fuel injector connector terminal B and PCM connector terminal 3X to ground
- No.3 cylinder fuel injector connector terminal B and PCM connector terminal 3Y to ground
- No.4 cylinder fuel injector connector terminal B and PCM connector terminal 3Z to ground