Without Scan Tool

Post Repair Procedures

Memory cancel
The ABS control module has a nonvolatile memory. Diagnostic trouble codes are not erased if the battery is disconnected. The memory should be cleared when servicing is finished. Diagnostic trouble codes memorized in the ABS control module are canceled by performing the following steps.
1. Connect the TBS terminal to GND at the data link connector.
2. Turn the ignition switch to ON.
3. Output all memorized codes.

4. After verifying that the first code is repeated, depress the brake pedal 10 times at intervals of less than one second (1 Sec.).

1. Diagnostic trouble codes cannot be canceled if the following occur.
1. If intervals of depressing the brake pedal exceeded one second (1 sec.).
2. Brake switch has failed.

NOTE: While performing the memory cancel operation, the ABS warning light will indicate DTCs. When the memory cancel operation is completed, the ABS warning light will stop flashing.

5. Turn oft the ignition switch to reset the control module.

NOTE: After repairing the ABS wheel-speed sensor or ABS pump, the ABS warning light may not go off when ignition is switched to ON. In this case, drive the vehicle at a speed of more than 20 kph (12.4 mph) to turn off the ABS warning light.