Road Test Procedures

Road Test [LJ4A-EL]
Road Test Preparation
1. Inspect the engine coolant.
2. Inspect the engine oil.
3. Inspect the ATF level.
4. Inspect the ignition timing.
5. Inspect the idle speed.

D Range Test
1. Perform road test preparation.
2. Shift the selector lever to D range.
3. Accelerate the vehicle with half and wide open throttle.
4. Verify that 1 -> 2, 2 -> 3, and 3 -> 4 upshifts and downshifts are obtained. The shift points must be as shown in the vehicle speed at shift point table.
5. Drive the vehicle in fourth, third, and second gear and verify that kickdown occurs for 4 -> 3, 3 -> 2, 4 -> 1, 3 -> 2, 3 -> 1, 2 -> 1, downshifts, and that the shift points are as shown in the vehicle speed at shift point table.
6. Drive the vehicle and verify that TCC operation is obtained. The operation points must be as shown in the vehicle speed at shift point table.
7. Select HOLD mode.
8. Accelerate the vehicle with half and wide open throttle, and verify that 2 -> 3 upshift and downshift are obtained. The shift points must be as shown in the vehicle speed at shift point table.





Vehicle Speed At Shift Point

S Range Test
1. Perform road test preparation.
2. Shift the selector lever to S range.
3. Accelerate the vehicle with half and wide open throttle.
4. Verify that 1 -> 2 and 2 -> 3 upshifts and downshifts are obtained. The shift points must be as shown in the vehicle speed at shift point table.
5. Drive the vehicle in third and second gear and verify that kickdown occurs for 3 -> 2, 3 -> 1, 2 -> 1, and that the shift points are as shown in the table concerning vehicle speed at shift point.
6. Decelerate the vehicle and verify that engine braking effect is felt in first, second, and third gear.
7. Drive the vehicle and verify that TCC operation is obtained.
8. Select HOLD mode.
9. Accelerate the vehicle with half- and wide open throttle, and verify that second gear is held. The shift points must be as shown in the vehicle speed at shift point table.
10. Decelerate the vehicle and verify that engine braking effect is felt.
11. Drive the vehicle and verify that TCC operation is obtained.





Vehicle Speed At Shift Point

L Range Test
1. Perform road test preparation.
2. Shift the selector lever to L range.
3. Accelerate the vehicle with half and wide open throttle.
4. Verify that 1 -> 2 upshift and downshift are obtained. The shift points must be as shown in the vehicle speed at shift point table.
5. Drive the vehicle in second gear and verify that kickdown occurs for 2 -> 1, and that the shift point is as shown in the vehicle speed at shift point table.
6. Decelerate the vehicle and verify that engine braking effect is felt in second gear.
7. Select HOLD mode.
8. Accelerate the vehicle with half- and wide open throttle, and verify that first gear is held.





Vehicle Speed At Shift Point

P Position Test
- Shift into P position on a gentle slope, release the brake, and verify that the vehicle does not roll.