Transmission Temperature Sensor/Switch: Testing and Inspection

Transaxle Fluid Temperature Sensor Inspection [LJ4A-EL]
1. Remove the control valve body.
2. Remove the transaxle fluid temperature sensor and solenoid valves.





3. Place the transaxle fluid temperature sensor in water with a thermometer as shown and heat the water gradually.





4. Measure resistance between the terminals of the transaxle fluid temperature sensor.
5. If not correct, replace the transaxle fluid temperature sensor.
6. Install the transaxle fluid temperature sensor and solenoid valves.
Tightening torque 6.9 - 8.8 Nm (70 - 90 kgf-cm, 61 - 78 inch lbs.)
7. Install the control valve body.
8. Carry out the line pressure test.