Driver Side - Air Bag Module

WARNING:
Handling the air bag module improperly can accidently deploy the air bag, which may seriously injure you. Read AIR BAG SYSTEM SERVICE WARNINGS before handling the air bag module. Service Precautions

Driver's Side Air Bag:

1. Turn the ignition switch to LOCK.
2. Disconnect the negative battery cable and wait for more than 1 minute to allow the backup power supply of the SAS unit to deplete its stored power.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Turn the ignition switch to ON.
6. Verify that the air bag system warning light illuminates for approximately 6 seconds then goes off.
7. If the air bag system warning light remains on, off, or repeats flashing after servicing, there are malfunctions in the system. Carry out the inspection again. (Refer to AIR BAG SYSTEM ON BOARD DIAGNOSIS.) Testing and Inspection





Bolt Installation Note
Tighten the bolts in the order shown in the figure.