Torque Converter Clutch Solenoid: Service and Repair

SOLENOID VALVES REMOVAL/INSTALLATION
1. Disconnect the solenoid connector.





2. Remove the control valve body.
3. Remove the solenoid valve.





4. Apply ATF to a new O-ring and install it, a new solenoid valve, and the oil strainer component.

Tightening torque 7.9 - 10.7 Nm (80 - 110 kgf-cm, 70 - 95 inch lbs.)

5. Install the control valve body.
6. Lightly apply silicone sealant to both sides of a new oil pan gasket.





7. Install the new gasket and install the oil pan.

Tightening torque 8.4 - 10.7 Nm (85 - 110 kgf-cm, 74 - 95 inch lbs.)

8. Connect the solenoid connector.
9. Connect the negative battery cable.
10. Carry out the time lag test and line pressure test.
11. Carry out the road test.