Front Cross-Member: Service and Repair

REMOVAL/INSTALLATION

CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled by mistake while serviceing the vehicle.

1. Remove in the order indicated in the illustration, noting the following steps.
2. Install in the reverse order of removal indicated in the table.

Front Crossmember And Steering Gear Component (9)
1. Support the crossmember by using a jack being careful to not let the crossmember fall, and remove the bolts and nuts.
2. Remove the front crossmember and steering gear component.