Fuel Injector Installation Note

1. Apply a small amount of clean engine oil to the new O-rings, and install them.
2. Verify that the fuel injector holder is clean.
3. Clean the holder with gasoline, as necessary.
4. Install the fuel injector squarely into the fuel distributor while turning it back and forth.
5. Fit the fuel injector tab into the notch in the fuel distributor.
6. When installing accumulated connector, install the fuel injector as shown in the figure.

Tightening torque
2.5 - 3.5 N.m {25 - 36 kgf.cm, 22 - 31 in.lbf}