Removal and Installation

SELECTOR LEVER AND CABLE REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the steering column cover.
3. Remove the side panel.
4. Remove the lower panel.
5. Remove the front console.
6. Remove the heater unit.
7. Remove the SAS unit bracket.
8. Remove in the order indicated in the table.
9. Install in the reverse order of removal.
10. Install the SAS unit bracket.
11. Install the heater unit.
12. Install the front console.
13. Install the lower panel.
14. Install the side panel.
15. Install the steering column cover.
16. Connect the negative battery cable.





Indicator Panel Removal Note
Remove the indicator screws and lift up the indicator panel

Selector Lever Removal Note
1. Slide the lock cover.





2. Disconnect the set button.
3. Remove the selector lever.
4. Pull out the selector cable from the selector lever.
5. Remove the interlock cable from the selector lever.

Selector Cable Removal Note
1. Disconnect the selector cable from the manual shaft lever on the transaxle.





2. Pull out the selector cable from the cable bracket and remove it.

Interlock Cable Installation Note
1. Verify that the ignition switch is in LOCK position, and shift the selector lever in P position.





2. Install the lock unit.

Tightening torque 4.3 - 6.2 Nm (43 - 63 kgf-cm, 38 - 54 inch lbs.)





3. Install the interlock cable. (key side)

Tightening torque 4.3 - 6.2 Nm (43 - 63 kgf-cm, 38 - 54 inch lbs.)

4. Install the interlock cable (selector lever side) onto the interlock cam on the selector lever.





5. Fit the interlock cable in the U-groove in the selector lever base plate.

CAUTION: Applying load to the interlock cable while pressing the lock piece in can affect the lock unit operation.

NOTE: Step 6 and 7 are for the interlock cable replacement only.









6. Press the lock piece in until it is locked.





7. Remove the lock unit lock pin in the order shown in the figure.

Selector Cable Installation Note
1. Shift the selector lever and manual shaft to P position (KL), or D range (FS).





CAUTION: Bending the selector cable in the manner shown in the figure will damage the cable and cause it to become loose during shifting, when handling and installing the selector cable, hold it straight.

2. Install the selector cable to the cable bracket.
3. Install the clip to the selector cable.





4. Connect the selector cable to the manual shaft lever on the transaxle.

Selector Lever Installation Note
1. Install the selector lever.
2. Install the selector cable to the selector lever.

Tightening torque 16 - 22 Nm (1.6 - 2.3 kgf-m, 12 - 16 ft. lbs.)

3. Shift the selector lever to P position (KL), or D range (FS).
4. Connect the set button.





5. Slide the lock cover and lock the set button.

Indicator Panel Installation Note
1. Shift the selector lever to P position.





2. Align the alignment screws in the slider with the holes in the indicator panel. Install heavy-gauge wire to hold the slider.





3. Tighten the indicator panel screws in the order shown in the figure.

Tightening torque 2.0 - 2.9 Nm (20 - 30 kgf-cm, 18 - 26 inch lbs.)

4. Remove the heavy gauge wire.
5. Verify that the selector lever properly aligns with the indicator in each range.