Disassembly and Assembly

SELECTOR LEVER DISASSEMBLY/ASSEMBLY
1. Disassemble in the order indicated in the table.





2. Assemble in the reverse order of disassembly.

Connector Disassembly Note
1. Insert a thin piece of metal from the terminal side of the connector, and lift up the terminal locking tab.
2. Pull the terminal out of the connector.

Indicator Panel Assembly Note
1. Shift the selector lever to P position.





2. Align the alignment screws in the slider with the holes in the indicator panel. Install heavy-gauge wire to hold the slider.
3. Temporarily install the indicator panel to the selector lever bracket.





4. Tighten the indicator panel screws in the order shown in the figure.

Tightening torque 2.0 - 2.9 Nm (20 - 30 kgf-cm, 18 - 26 inch lbs.)

5. Remove the heavy gauge wire.
6. Verify that the selector lever properly aligns with the indicator panel in all ranges and positions.