Driver-Side Air Bag Module

WARNING:
^ Handling the air bag module improperly can accidently deploy the air bag module which may cause serious injury. Read AIR BAG SYSTEM SERVICE WARNINGS before handling the air bag module. (Refer to AIR BAG SYSTEM SERVICE WARNINGS.)




1. Turn the ignition switch to LOCK.
2. Disconnect the negative battery cable and wait for more than 1 minute to allow the backup power supply of the SAS unit to deplete its stored power.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Turn the ignition switch to ON.
6. Verify that the air bag system warning light illuminates for approximately 6 seconds then goes off.
7. If the air bag system warning light remains on, remains off, or continuously flashes after servicing, there are malfunctions in the system. Repeat inspection again. (Refer to AIR BAG SYSTEM ON-BOARD DIAGNOSIS.)




Bolt Installation Note
^ Tighten the bolts in the order shown in the figure