How to Clear Diagnostic Trouble Codes - ABS

1. Connect the Special Service Tool (SST) (NGS tester) to the data link connector and select READ/CLEAR DIAGNOSTIC TEST RESULTS in the same procedure as the reading DTCs procedure. Press the trigger key to enter this selection.
2. Press CLEAR.
3. Press the trigger key.

NOTE:
^ After repairing the ABS wheel-speed sensor or pump motor, the ABS warning light may not go off when ignition is switched to ON. In this case, drive the vehicle at a speed of more than 10 km/h (6.2 mph). After the ABS warning light goes off, reset the memory.