Fuel Injector: Service and Repair
REMOVAL/INSTALLATIONWARNING: Fuel line spills and leaks are dangerous. Fuel can ignite and cause serious injuries or death and damage. Fuel can also irritate skin and eyes. To prevent this , always complete the "Fuel Pressure Release Procedure".
Fuel Pressure Release
1. Disconnect the negative battery cable.
2. Remove in the order shown in the figure.
3. Install in the reverse order of removal.
Installation Note
1. Apply a small amount of clean engine oil to the new 0- rings, and install them.
2. Verify that the fuel injector holder is clean.
3. Clean the holder with gasoline, if necessary.
4. Install the fuel injector squarely into the distribution pipe while turning it back and forth.
5. Fit the fuel injector tab into the notch in the distribution pipe.
6. When installing accumulated harness, install the fuel injector as shown in the figure.
Tightening torque: 2.5-3.5 Nm (22-31 in.lbs.)