Using EC-AT Tester

Part 1 Of 2:

Part 2 Of 2:

Part 1 Of 2:

Part 2 Of 2:

NOTE: Do not connect the NGS to the data link Connector 2 when EC-AT tester is connected to the transmission control module. Doing so can cause incorrect test results.





WHEN USING THE EC-AT TESTER (49 G019 901) AND ADAPTER (49 H019 902)
1. Assemble the Special Service Tool (SST).
2. Set the SST (49 H019 902) vehicle switch to 929 position.
3. Turn the ignition switch and EC-AT tester main switch to ON
4. Check the indication of the respective light or digital display in each condition, referring to the indication table.





WHEN USING THE EC-AT TESTER (49 G019 901 B)
1. Assemble the SST.
2. Set the SST (49 G019 901 B) vehicle switch to 929 position.
3. Turn the ignition switch and the EC-AT tester main switch to ON.
4. Check the indication of the respective light or digital display in each condition, referring to indication table.





WHEN USING THE EC-AT TESTER (49 G019 901 C)
1. Assemble the SST.
2. Turn the SST select switch to the black diamond mark on the panel.
3. Turn the ignition switch and the SST main switch to ON.
4. Check the indication of the respective light or digital display in each condition, referring to the indication table.