Using the EC-AT Tester (49 GO19 901C)

INSPECTION PROCEDURE

CAUTION: Do not connect the New Generation Star (NGS) tester to the data link connector 2 when EC-AT tester is connected to the powertrain control module. Doing so can cause incorrect test results.

When Using the EC-AT Tester (49 G019 901C)




1. Assemble the SST.




2. Turn the EC-AT tester select switch to the A mark on the panel.




3. Turn the ignition switch and the EC-AT tester main switch to ON.




4. Check indication of the respective light or digital display in each condition, referring to the indication table.