Air Flow Meter/Sensor: Service and Repair

WARNING: Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel line spills and leaks are dangerous. Fuel can ignite and cause serious injuries or death and damage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Pressure Release Procedure".

Fuel Pressure Release

REMOVAL / INSPECTION / INSTALLATION
1. Remove in the order shown in the figure.
2. Inspect all parts and repair or replace as necessary.
3. Install in the reverse order of removal.

Intake Components:

1. Fresh-air duct
2. Air cleaner
3. Volume air flow sensor
4. Air intake hose
5. Accelerator cable
6. Fuel pipe
7. Intake manifold (Inspect)
8. Throttle body (Inspect)
9. BAC valve
10. Air intake pipe (Inspect)
11. Fuel distributor

Removal Notes

Fuel Pump Relay Location:

Fuel Hose

Radiator Hose And Drain Plug Locations:

Water Hose
1. Loosen the drain plug and drain the coolant from the radiator. 2. Remove the water hose from the BAC valve.
3. After installation of the throttle body, refill the radiator.

Installation Note

Air Intake Pipe Installation Note:

Air Intake Pipe
1. Apply a small amount of clean engine oil to new 0-rings before installing them.
2. Install the air intake pipe.

Tightening torque: 7.9-10.7 Nm (70-95.4 in.lbs.)