Using NGS Scan Tool

Using NGS





1. Connect the SST (NGS) to the data link connector and battery.
2. Set the SST (Super MECS Adapter) to AUX 2.





3. Select "VEHICLE & ENGINE SELECTION" on the SST (Control Unit) display, and then select the vehicle model, engine type, and model year.





4. Select "DIAGNOSTIC DATA LINK" on the SST (Control Unit) display.
5. Select "CCM-CRUISE CONTROL MODULE" on the SST (Control Unit) display, and then select the "DIAGNOSTIC TEST MODE".





6. Select "CRUISE CONTROL INPUT SW SELF TEST" on the SST (Control Unit) display.
7. Press START.
8. Press TRIGGER.
9. Turn the ignition switch to ON.
10. Press and hold the RESUME/ACCEL switch, then press the cruise control main switch to activate system inspection.
11. Operate each switch as it is stated on the Diagnostic trouble code table. If a diagnostic trouble code shown in the table does not appear on the SST (Control Unit) display, inspect the corresponding system area.

NOTE: Wait 5 seconds after last switch DTC has finished flashing before starting next switch test.