Using Cruise Set Indicator Light

Using cruise set indicator light

Inspection

NOTE: If the RESUME/ACCEL switch on the cruise control switch is malfunctioning, the cruise set indicator light will not give a correct indication when you inspect the system. Use the SST (NGS set) to determine the cause of the malfunction.





1. Turn the ignition switch to ON.
2. Verify that the cruise control main switch is off.
3. Shift the transaxle to D or R range. (ATX)
Do not depress the clutch pedal. (MTX)





4. Press the RESUME/ACCEL switch and the cruise control main switch simultaneously to activate system inspection. (The cruise set indicator light will illuminate.)
5. Operate each switch as described and note the diagnostic trouble code pattern. If the cruise set indicator light does not flash, inspect the corresponding system area.

NOTE: Wait 5 seconds after last switch DTC has finished flashing before starting next DTC switch test.

Canceling operation mode
To cancel operation mode, do any one of the following:
^ Turn off the cruise control main switch.
^ Turn the ignition switch to LOCK.