Using NGS Scan Tool

Using NGS





1. Turn on the cruise control main switch.
2. Drive the vehicle.
3. Operate the cruise control system and verify that the deceleration, acceleration, coast, and cancel controls function by operating each of the cruise control switches.
4. Stop the vehicle and let it idle.
5. Connect the SST (NGS) to the data link connector and battery.
6. Set the SST (Super MECS Adapter) to AUX 2.





7. Select "VEHICLE & ENGINE SELECTION" on the SST (Control Unit) display, and then select the vehicle model, engine type, and model year.





8. Select "DIAGNOSTIC DATA LINK" on the SST (Control Unit) display.
9. Select "CCM-CRUISE CONTROL MODULE" on the SST (Control Unit) display, and then select the "DIAGNOSTIC TEST MODE".





10. Select "CRUISE CONTROL SELF TEST" on the SST (Control Unit) display.
11. Press START
12. Press TRIGGER.
13. (1) If a diagnostic trouble code is displayed, refer to the diagnostic trouble code table and inspect the appropriate system area.
(2) If "NO CODES RECEIVED" is displayed, the system areas shown in the diagnostic trouble code table are okay. Inspect another system area.
14. After the problems are corrected, repeat the condition detection mode procedure to verify that the system is operating normally.

Canceling condition detection mode
To cancel condition detection mode, do any one of the following:
^ Turn off the cruise control main switch.
^ Turn the ignition switch to LOCK.