Transaxle

1. Battery box
2. Battery
3. Air cleaner assembly
4. Battery carrier
5. Back-up light switch connector
6. Back-up light switch connector bracket
7. Neutral switch connector
8. Vehicle speedometer sensor connector
9. Harness bracket
10. Wheel and tire
11. Splash shield
12. Transverse member
13. Extension bar
14. Change control rod
15. Tie-rod end
16. Stabilizer control link
17. Joint shaft
18. Drive shafts
19. Intake manifold bracket
20. Starter
21. Engine mounting member
22. No.1 engine mount
23. No.2 engine mount
24. Clutch release cylinder
25. No.4 engine mount
26. Transaxle

1. Drain the transaxle oil.
2. Remove in the order shown in the image, referring to Removal Note.
3. Install in the reverse order of removal, referring to Installation Note.
4. Add the specified amount and type of transaxle oil. Service and Repair
5. Warm up the engine and transaxle, inspect for oil leakage, and check transaxle operation.




Removal Note
Engine mounting member
1. Suspend the engine by using the SST.
2. Remove the engine mounting member.




Transaxle
1. Loosen the SST (engine support) and lean the engine toward the transaxle.
2. Support the transaxle on a jack.
3. Remove the transaxle bolts.
4. Remove the transaxle.

WARNING: Do not allow the transaxle to fall from the jack.




5. Remove the transaxle mounting bolts.
6. Remove the transaxle.




Installation Note
Transaxle
1. Set the transaxle on a jack and carefully lift into place.
2. Install the transaxle mounting bolts.

Tightening torque: 64 - 89 N-m (6.5 - 9.1 kgf-m, 48 - 65 ft-lbf)

3. Hand-tighten the No.4 engine mount bolts and nuts.




No.2 engine mount
Hand-tighten the No.2 engine mount rubber nut.




No.1 engine mount

CAUTION: Misaligning the bolts will cause damage to the bolt holes.

1. Use the SST (engine support) to make sure the transaxle bolt holes and No.1 engine mount meet evenly.
2. After the 3 bolts are set in the holes, tighten the bolts to the specified torque.

Tightening torque: 67 - 93 N-m (6.8 - 9.5 kgf-m, 50 - 68 ft-lbf)




Engine mounting member

NOTE:
- Verify that the engine mount rubbers are installed as shown.
- Put the No.1 engine mount stud bolts in the installation holes when installing the engine mounting member.




1. Install the bolts and nuts as shown.

Tightening torque
A: 67 - 89 N-m (6.8 - 9.1 kgf-m, 50 - 65 ft-lbf)
B: 38 - 51 N-m (3.8 - 5.3 kgf-m, 28 - 38 ft-lbf)

2. Tighten the No.2 engine mount rubber nut.

Tightening torque: 67 - 93 N-m (6.8 - 9.5 kgf-m, 50 - 68 ft-lbf)




3. Tighten the No.4 engine mount bolts and nuts.

Tightening torque: 67 - 93 N-m (6.8 - 9.5 kgf-m, 50 - 68 ft-lbf)

4. Remove the SST (engine support).