With EC-AT Tester (49 GO19 901C)

Inspection Using EC-AT Tester (49 GO19 901C)

CAUTION: Do not connect the new generation star tester (NGS) to the data link connector-2 when the EC-AT tester is connected to the transaxle control module. Doing so can cause incorrect test results

View: Assembly Of Special Service Tools:

1. Assemble the special service tools (SST)s as shown above.




2. Set the SST select switch to the triangle mark on the panel as shown above.
3. Turn the ignition switch and EC-AT tester main switch to ON.
4. Check the indication of the respective light or digital display in each condition, referring to the indication table below.

Refer to Indication Table below when using the following SST tool combination.

Indication Table Of Light And Digital Display:

EC-AT Tester (49 G019 901C)