With EC-AT Tester (49 GO19 901B)

Inspection Using EC-AT Tester (49 GO19 901B) and Adapter Unit (49 L019 901), and Adapter Unit (49 L019 901) or Adapter Unit (49 L019 901 A)

CAUTION: Do not connect the new generation star tester (NGS) to the data link connector-2 when the EC-AT tester is connected to the transaxle control module. Doing so can cause incorrect test results

View: Assembly Of Special Service Tools:

1. Assemble the special service tools (SST)s as shown above.




2. Set the SST (49 H019 902 and 49 L019 901A) vehicle switch to 929 position.
3. Turn the ignition switch and EC-AT tester main switch to ON.
4. Check the indication of the respective light or digital display in each condition, referring to the indication table(s) below.

Refer to Indication Table below when using the following SST tool combinations.

Indication Table Of Light And Digital Display:

EC-AT Tester (49 G019 901) and Panel (49 H019 910) or EC-AT Tester (49 G019 901B) and Panel (49 H019 909)


Refer to Indication Table below when using the following SST tool combinations.

Indication Table Of Light And Digital Display:

EC-AT Tester (49 G019 901) and Panel (49 H019 907) or EC-AT Tester (49 G019 901B) and Panel (49 H019 906)