Clearing Trouble Codes

After-Repair Procedure
1. Cancel the diagnostic trouble code memory by using the SST (New Generation Star Tester).
(Refer to the Instruction Manual)
2. Remove the SST (New Generation Star Tester) from the data link connector 2.




3. Drive the vehicle at 50 km/h (31 mph) and depress the accelerator pedal fully to activate kickdown. Stop the vehicle gradually.




4. Connect the SST (New Generation Star Tester) to the data link connector 2 and battery.
5. Turn the ignition switch ON.
6. Verify that no diagnostic trouble code are displayed.