Component Tests and General Diagnostics

Inspection
Resistance
1. Disconnect the crankshaft position sensor connector.
2. Measure the resistance between terminals A and B by using an ohmmeter.

Specification: 950-1,250 (1,100 ± 150) ohms

3. If not as specified, replace the crankshaft position sensor.




Air Gap
1. Measure the air gap between crankshaft pulley and crankshaft position sensor by using a feeler gauge.

Specification:
0.5-1.5 (1.0 ± 0.5) mm (0.040-0.080 in)

2. If not as specified, replace the crankshaft pulley or the crankshaft position sensor.




NE Signal Illustration
- After warm-up idle with no load condition.