Brake Light Switch: Testing and Inspection
Inspection of Voltage1. Turn the ignition switch ON.
2. Measure voltage at the brake switch connector.
3. If not as specified, check the wiring harness (Stop fuse- Brake switch, Brake switch-transaxle control module) and the continuity of the switch.
Inspection of Continuity
1. Disconnect the negative battery cable.
2. Disconnect the brake switch connector.
3. Check continuity between terminals A and B of the switch.
4. If not as specified, replace the brake switch.
5. Connect the brake switch connector.
6. Connect the negative battery cable.