Air Bag Control Module: Service and Repair

1. Carry out the "Before Servicing" procedure under GENERAL PROCEDURES. Service and Repair

2. Remove the dashboard.
3. Remove the heater unit.





4. Remove in the order shown in the figure.
5. Install in the reverse order of removal, referring to Installation note.
6. Follow the troubleshooting flowchart to verify that the air bag system is operating normally. Flow of Diagnosis

Installation note:

1. If the bracket mounting area is damaged, repair the area to its original shape.








2. Position the SAS-unit and bracket with the arrow on the SAS-unit facing toward the front of vehicle. Install them and tighten the bolts and nuts in the order shown in the figure to the specified torque.

Tightening torque: 6.87-9.80 Nm (60.8-86.7 in lb)