Clearing Diagnostic Trouble Codes

AFTER REPAIR PROCEDURE
Cancel the memory of diagnostic trouble code by disconnecting the negative battery cable and depressing the brake pedal for at least 20 Sec.. Reconnect the negative battery cable.




SELF-DIAGNOSIS CHECKER
1. Connect the SST (System Selector) to the data link connector.
2. Set system select to position 1.
3. Set the test switch to SELF TEST.




4. Connect the SST (Self-Diagnosis Checker) to the System Selector and a ground.
5. Set the select of the Self-Diagnosis Checker to position A.
6. Turn the ignition switch ON.
7. Verify that no diagnostic trouble codes are displayed.