With Manual Transaxle (MTX)

1. Disconnect negative battery cable.
2. Remove the fresh-air duct.
3. Remove in the order shown in the figure.
4. Install in the reverse order, referring to Installation Note.




Installation Note
1. Verify that the No.1 cylinder is at top dead center and the distributor matching marks are aligned.
2. Install the distributor and connect the high-tension leads and distributor connector.
3. Tighten the locknut or bolts to the specified torque.

Torque specification:
19-25 N.m (1.9-2.6 kg-m, 14-18 ft-lb)