Manual Trans.

REMOVAL/INSPECTION/INSTALLATION
1. Remove in the order shown in the figure.
2. Inspect the intake air system components and repair or replace them as necessary.
3. Install in the reverse order of removal.




1. Fresh air duct
Inspect for damage
2. Air cleaner
Inspect for excessive dirt and damage
3. Air cleaner element
Inspection
4. Mass air flow sensor
Inspection
5. Air hose
Inspect for damage
6. Resonance chamber Inspect for damage
Inspect for damage
7. Accelerator cable
Inspection/Adjustment
8. Throttle body
Inspection
9. BAC valve
Inspection
10. [1][2]Intake manifold bracket
11. [1][2]Intake manifold




[1][2]Intake Manifold Installation Note
1. Tighten the bolts in the order shown in the figure.

Tightening torque:
19-25 N-m (14-18 ft-lb)

2. Refill the radiator with the specified engine coolant.
3. Check for engine coolant leakage.





Throttle Body Inspection Note
1. Check the throttle body for wear, deposits, and coolant leakage.
2. Verify that the throttle valve moves smoothly when the throttle lever is moved from closed throttle position to wide open throttle.
3. Replace the throttle body if necessary.

Caution
- Do not remove the thin seal coating from the throttle valve or bore. It is necessary for proper operation.


Resonance Chamber Installation Note




1. Slide the hose clamp onto the hose and push it onto resonance chamber.




2. Rotate the hose and hook it securely onto the locating knob.




3. Tighten the hose clamp.