Oil Seal (Change Rod Assembly)

1. Disconnect the speedometer cable and remove the speedometer driven gear. Service and Repair
2. Remove the drain plug and washer. Drain the oil into a suitable container.
3. Disconnect the change control rod from the transaxle.
4. Remove the joint and boot from the change rod assembly.




5. Remove the oil seal.




6. Install a new oil seal by using a 26mm (1.024 in) diameter pipe.
7. Coat the lip of the oil seal with transaxle oil.




8. Install the boot and joint to the change rod assembly so that the drain hole is facing downward.

Tightening torque: 13.8-18.7 N.m (140-190 kgf.cm, 122-164 in.lbf)

9. Connect the change control rod to the change rod assembly.

Tightening torque: 16-22 N.m (1.6-2.3 kgf.m, 12-16 ft.lbf)




10. Add the specified amount and type of oil. Service and Repair