Air Cleaner Housing: Service and Repair

Intake System Components:

1. Remove components in order shown, referring to REMOVAL NOTE.
2. Inspect parts and replace as needed.
3. Install in reverse order of removal. Refer to INSTALLATION NOTE.

COMPONENTS

1. Fresh air duct.
2. Air cleaner housing.
3. Air flow sensor.
4. Air intake hose.
5. Accelerator cable.
6. Fuel pipe.
7. Intake manifold.
8. Throttle body.
9. BAC valve.
10. Air intake pipe.
11. Fuel distributor.

REMOVAL NOTE

1. Before disconnecting fuel distributor, relieve fuel pressure.
2. Drain coolant before removing water hose from BAC valve.


INSTALLATION NOTE

Air Intake Pipe Installation:

1. Apply small amount of clean engine oil to new air intake pipe O-rings. Use care not to damage O-rings during installation.
2. Tighten bolts to specification:

TORQUE: 70 - 95.4 inlb (7.9 - 10.7 Nm)