Manual Transaxle 4WD

DISASSEMBLY-STEP 2
Disassemble in the sequence shown in the image.














Bearing Outer Race
1. Install the SST.




2. Remove the bearing outer races.

NOTE: Do not remove the oil seals unless replacement is necessary because of damage.




3. Remove the bearing outer race by lifting the Tunnel and the race out together.




Oil Seal
Check the oil seals and if necessary replace them.
Use a pipe of the proper size to tap the seal out.

NOTE: Remove the oil seal gradually and evenly.




Clutch Housing
1. Remove the roll pin and crank lever.




2. Remove the roll pin and inner shift lever.




3. Remove the base plate.