Seat Cushion - Front
SEAT CUSHION - FRONTPart 1:
Part 2:
Disassembly
All seats
1. Remove the affected seat.
Passenger seat with OCS
2. To disassemble a passenger seat cushion equipped with an OCS system, remove the OCS.
All seats
3. Remove the front seat backrest.
4. Remove the seat track
Heated seats
5. Disconnect the heated seat electrical connector.
6. Remove the wiring harness connector. Note the wiring harness routing for installation.
All seats
7. Release the J-clips.
Seats with power lumbar
8. Disconnect the power lumbar switch electrical connector.
9. Insert a screwdriver between the bezel and the power lumbar switch. Pry the tab and push the switch through the bezel.
10. Remove the power lumbar switch.
All seats
11. Remove the seat cushion frame from the foam pad and trim cover.
12. NOTE: Note the number and location of the hog rings during disassembly.
Remove and discard the hog rings. Remove the seat cushion trim cover.
13. If necessary, remove the 2 pin-type retainers and the mat. Otherwise, position the mat aside.
14. Remove the backrest support.
Assembly
Passenger seat with OCS
1. To assemble a passenger seat cushion equipped with an OCS system, install the OCS.
All seats
2. Install the backrest support.
3. Position the mat over the backrest support and install the 2 pin-type retainers.
4. Install new hog rings at the locations noted during disassembly.
5. Position the seat cushion foam pad and trim cover to the seat cushion frame.
Seats with power lumbar
6. Install the power lumbar switch until seated into the bezel.
7. Connect the power lumbar switch electrical connector.
All seats
8. Install the wiring harness. Route the harness wiring as noted during disassembly.
9. Fasten the J-clips.
Heated seats
10. Connect the heated seat electrical connector.
All seats
11. Install the seat track.
12. Install the front seat backrest.
13. Install the affected seat.