Selector Lever Cable Adjustment
Selector Lever Cable Adjustment1. WARNING: Shut off the electrical power to the air suspension system prior to hoisting or jacking an air suspension equipped vehicle. Failure to do so may result in unexpected inflation or deflation of the air springs, which may result in shifting of the vehicle during these operations. Failure to follow this instruction may result in serious personal injury.
With the vehicle in NEUTRAL, position it on a hoist.
2. Place the selector lever in the (D) position.
3. Hang a 1.4 kg (3 lb) weight on the selector lever.
4. Remove the nut and disconnect the selector lever cable from the manual control lever.
5. Position the manual control lever in the (D) position.
1 Pull the manual control lever forward until travel stops.
2 Push the manual control lever backward 2 detents to the (D) position.
6. Connect the selector lever cable to the manual control lever and install the nut.
^ Tighten to 30 Nm (22 lb-ft).
7. Remove the weight.
8. Move the selector lever from detent to detent and compare it with the transmission setting. Verify that the engine will start in P and N and that the reversing lamps illuminate in R. If not, repeat the adjustment procedure.
9. Check that the digital transmission range (TR) sensor adjustment is correct. Adjust the TR sensor if necessary.
10. After completing all adjustments, and with the vehicle on the ground, turn on the electrical power to the air suspension, if equipped.