Test T: The Heated Seat Is Inoperative - Right Rear, Does Not Operate In Low

PINPOINT TEST T: THE HEATED SEAT IS INOPERATIVE - RIGHT REAR, DOES NOT OPERATE IN LOW

Normal Operation
The right rear heated seat module receives voltage feed on circuit 1445 (RD/LG), ignition voltage feed on circuit 1040 (RD/BK) and is supplied ground on circuit 57 (BK). When the heated seat control switch is pressed with the ignition switch in RUN or START, a ground signal is sent to the heated seat module on circuit 1256 (WH/YE) to command the system ON or OFF (LOW heat mode).

This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- Heated seat switch
- Heated seat module

T1-T3:

T3 Continued: