Manual
SEAT RECLINER - MANUALExploded View
Front Seat Backrest (Part 1):
Front Seat Backrest (Part 2):
Front Seat Cushion (Part 1):
Front Seat Cushion (Part 2):
Removal and Installation
WARNING: Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
NOTE:
- The air bag warning indicator illuminates when the correct restraints control module (RCM) fuse is removed and the ignition switch is ON.
- The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Position the affected seat all the way forward and up.
2. Depower the SRS.
3. WARNING: Front seat backrest trim covers installed on seats equipped with seat side air bags cannot be repaired. A new trim cover must be installed. Cleaning is permissible. Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and increase the risk of serious personal injury or death in a crash.
NOTE: Note the alignment of the 2 side J-clips at the top of the seat to avoid bunching of the trim cover material during installation.
Release the seat backrest trim cover J-clips.
- Release the lower J-clip first and then release the 2 side J-clips.
4. remove the backrest handle.
5. Release the J-clips.
6. Release the cushion trim cover rear J-clip.
7. Release the cushion trim cover rear hook-and-loop strip.
8. Remove the 2 recliner-to-backrest bolts.
- To install, tighten to 55 Nm (41 lb-ft).
9. Remove the 2 recliner-to-seat track bolts and the recliner assembly.
- To install, tighten to 55 Nm (41 lb-ft).
10. To install, reverse the removal procedure.
11. Repower the SRS.