Seat - Front

SEAT - FRONT







Removal

WARNING:
- Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.
- Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

NOTE:
- The air bag warning indicator illuminates when the correct restraints control module (RCM) fuse is removed and the ignition switch is ON.
- The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
- Driver shown, passenger similar.

1. Position the seat to allow access to the front and rear retainers.
2. Depower the SRS.
3. Remove the 2 rear seat track-to-floor nut covers.
4. Remove the 2 rear seat-to-floor nuts.
- The center safety belt buckle anchor can be separated from the seat track once the seat is removed.

5. Remove the 2 front seat track-to-floor bolt covers.
6. Remove the 2 front seat-to-floor bolts.
7. Disconnect the electrical connectors.







8. CAUTION: Use care when handling the seat. Dropping or sitting on a seat not secured in the vehicle may result in damaged components.

Remove the seat.

Installation

1. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

Install the seat in the vehicle.
- While installing and positioning the seat, make sure the center safety belt buckle anchor is positioned to go through the seat mounting stud.

2. Connect the electrical connectors.







3. Install the 2 front seat-to-floor bolts.
- Tighten to 25 Nm (18 lb-ft).

4. Install the 2 front seat track covers.
5. Install the inboard seat-to-floor nut.
- Before installing the rear inboard nut, make sure the center seat safety belt buckle anchor is positioned to go on the seat mounting stud.
- Tighten to 80 Nm (59 lb-ft).

6. Install the outboard seat-to-floor nut.
- Tighten to 25 Nm (18 lb-ft).

7. Install the 2 front seat track rear covers.
8. Repower the SRS.