Rear Door Window Regulator: Service and Repair

REAR DOOR WINDOW REGULATOR AND MOTOR

Part 1:

Part 2:

Removal and Installation
1. Remove the rear door trim panel.
2. Position the watershield aside.
3. Remove the 4 rivets and the pull handle retainer bracket.
4. Remove the rear door window regulator nuts.
- To install, tighten to 12 Nm (9 lb-ft).

5. Disconnect the rear door window regulator motor electrical connector.
6. Remove the 5 rear door window regulator rivets.
7. Remove the rear door window regulator and motor.
8. To install, reverse the removal procedure.