Test E: The Headlamps Are On Continuously

PINPOINT TEST E: THE HEADLAMPS ARE ON CONTINUOUSLY

E1-E3:

E4-E8:

E8-E14:

E14-E16:

E16-E18:

E18-E20:

E20-E22:

E23-E24:

Normal Operation
The instrument cluster monitors the headlamp switch position. When the headlamp switch is in the HEADLAMPS ON position, the instrument cluster sends a message to the front electronic module (FEM) to illuminate the headlamps. If a problem is detected with the circuits to the headlamp switch, the instrument cluster defaults the headlamps on. The FEM controls the ground circuit for each halogen bulb or high intensity discharge (HID) relay (if equipped). If a problem is detected with any of the signal circuits to the headlamp switch, the instrument cluster defaults the parking lamps and headlamps on. The FEM controls the ground for the headlamp bulbs (and the HID relays, if equipped).

Possible Causes
- Circuit 31S-LE16 (BK/RD) (LH halogen low beam) short to ground
- Circuit 31S-LE23 (BK/WH) (RH halogen low beam) short to ground
- Circuit 91S-LE16 (BN/YE) (LH HID relay) short to ground
- Circuit 91S-LE23 (BN/WH) (RH HID relay) short to ground
- Circuit 31S-LE15 (BK/GN) (LH halogen high beam) short to ground
- Circuit 31S-LE22 (BK/RD) (RH halogen high beam) short to ground
- Circuit 8-LE21 (WH/GN) open, short to voltage or ground
- Circuit 8-LF14 (WH/BU) open, short to voltage or ground
- Circuit 9-LE29 (BN/GN) open or short to voltage
- Circuit 10-LE21 (GY/OG) open, short to voltage or ground
- Circuit 10-LE47 (GY/OG) short to ground
- HID relay
- Headlamp switch
- Instrument cluster
- FEM
- Headlamp assembly
- Multifunction switch