Seat Cushion Cover - Rear
SEAT CUSHION COVER - REARRemoval and Installation
1. Using a suitable tool, release the mini-buckle.
2. Release the 2 levers located at the lower outboard edges of the seat cushion, lift the cushion up and pull the cushion out.
3. If equipped, disconnect the heated seat electrical connectors at both outboard sides of the seat cushion.
4. Remove the seat cushion.
5. Remove all the outer seat cushion trim cover hog rings.
6. CAUTION: Use care when separating the seat upholstery from the hook and loop strip, or the hook and loop strip can be torn from the seat cushion foam pad.
Separate the hook and loop fasteners.
7. Remove all the inner seat cushion trim cover hog rings.
8. Remove the seat cushion trim cover.
9. To install, reverse the removal procedure.