Front Bumper Reinforcement: Service and Repair

FRONT BUMPER

Part 1:

Part 2:

Exploded View

Removal and Installation
1. Remove the front bumper cover.
2. Remove the front bumper isolator.

3. NOTE: Spot welding the bumper is not required for installation.

Drill out the 6 front bumper spot welds.

4. Remove the 8 bolts and the front bumper.
- To install, tighten the 6 front bumper bolts to 25 Nm (18 lb-ft).
- To install, tighten the 2 front bumper bolts to 10 Nm (89 lb-in).

5. To install, reverse the removal procedure.