Extension Housing Gasket

Extension Housing Gasket








Special Tool(s)

Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the driveshaft.





3. Remove the transmission insulator center screw.

4. NOTE: Use a suitable transmission jack to support the transmission.





Remove the 4 rear transmission crossmember screws.





5. Disconnect the shift cable retainer and position the cable aside.





6. Remove and discard the nut.





7. Using the special tool, remove the output shaft flange.

8. CAUTION: The parking pawl, parking pawl return and parking pawl shaft could fall out during removal of the extension housing.





Remove the 7 extension housing screws and the extension housing.





9. Remove and discard the extension housing gasket.

Installation
1. Clean the extension housing and install a new extension housing gasket. Make sure the park pawl is installed correctly.

2. CAUTION: Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup.





Install the extension housing and screws.
^ Tighten to 25 Nm (18 ft. lbs.).





3. Install the shift cable retainer.





4. Install the rear transmission mount center screw.
^ Tighten to 40 Nm (30 ft. lbs.).





5. Install the 4 screws and the rear transmission support.
^ Tighten to 55 Nm (41 ft. lbs.).





6. Using the special tools, install the output flange.





7. Install a new nut.
^ Tighten to 131 Nm (97 ft. lbs.).
8. Install the driveshaft.
9. Check the transmission fluid level.