RH

Valve Cover RH





Material








Removal

CAUTION: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.

1. Disconnect the battery ground cable.





2. CAUTION: The engine appearance cover is equipped with a noise suppressor. If the noise suppressor becomes separated from the engine appearance cover it must be positioned on the intake manifold prior to installing the engine appearance cover.

Remove the engine appearance cover and the noise suppressor (if detached).
3. Remove the air cleaner outlet pipe.
4. Remove the RH ignition coil on plugs.
5. Disconnect the VCT solenoid electrical connector.
6. Detach the 3 wiring harness retainers and position the wiring harness aside.
7. Remove the crankcase ventilation tube.
8. Remove the 2 nuts and the RH engine appearance cover bracket.





9. NOTE: The valve cover bolts are not to be removed from the valve cover.

Loosen the bolts in the sequence shown.
^ Remove the RH valve cover.
^ Discard the gaskets.

Installation

1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the surfaces. These tools cause scratches and gouges, which make leak paths. Use a plastic scraping tool to remove all traces of sealant.

Clean the valve cover, cylinder head and front cover sealing surfaces with silicone gasket remover and metal surface prep.





2. Install new gaskets.





3. NOTE: The valve cover must be installed and the bolts and stud bolts tightened within 4 minutes of sealant application.

Apply a 3 mm (0.12 inch) dot of silicone gasket sealant to the front cover to cylinder head joints.





4. Install the RH valve cover.
^ Tighten the bolts in the sequence shown to 10 Nm (89 inch lbs.).

5. Install RH engine appearance cover bracket and the 2 nuts.
^ Tighten to 6 Nm (53 inch lbs.).

6. Install the crankcase ventilation tube.
7. Position the wiring harness and attach the 3 wiring harness retainers.
8. Connect the VCT solenoid electrical connector.
9. Install the LH ignition coil on plugs.
10. Install the air cleaner outlet pipe.





11. CAUTION: The engine appearance cover is equipped with a noise suppressor. If the noise suppressor becomes separated from the engine appearance cover it must be positioned on the intake manifold prior to installing the engine appearance cover.

Install the noise suppressor (if detached) and the engine appearance cover.
12. Connect the battery ground cable.