Part 1
Transmission
Material
1. Position and secure the transmission on a suitable high-lift transmission jack.
2. Connect the electrical connectors and install the wire harness from the transmission.
1. Connect the digital TR sensor electrical connector.
2. Connect the output shaft speed (OSS) sensor electrical connector.
3. Install the catalyst monitor connector retainer to the stud.
4. Connect the wire harness retainers and remove the harness.
3. Connect the electrical connectors.
1. Install the catalyst monitor connector retainer to the stud.
2. Connect the transmission solenoid body electrical connector.
4. Raise and position the transmission to the vehicle.
^ Align the balancing marks on the converter stud and the flexplate bolt hole.
5. Install the transmission retaining bolts.
6. Install the four torque converter nuts.
^ Rotate the crankshaft to access all the torque converter nuts.
7. Install the rubber access plug.
8. Install the transmission inspection cover.
1. Position the transmission inspection cover.
2. Install the two bolts.
3. Install the bolt for the separator plate.
9. Install the fluid filler tube.
10. Install the transmission filler tube bolt.
11. Install the rear transmission insulator.
12. Position the LH side of the crossmember into the crossmember pocket and loosely install the bolts.
13. Position the RH side of the crossmember into the crossmember pocket and loosely install the bolts.
14. Tighten the LH crossmember bolts.
15. Tighten the RH crossmember bolts.
16. Install the parking cable bracket.
17. Lower the transmission onto the crossmember and install the rear transmission insulator nuts.
18. Remove the high-lift transmission jack.
19. Install the fluid cooler tubes.
20. Install the transmission fluid cooler tube bracket.
21. Connect the transmission harness connectors to the filler tube bracket.