Removal and Installation

REMOVAL AND INSTALLATION

Special Tools And Equipment:

Special Tool(s)
1. With the vehicle in NEUTRAL, position on a hoist.
2. Remove the rear halfshafts.
3. Disconnect the driveshaft from the rear axle flange. Support the driveshaft at the center and rear.
4. Position a suitable hydraulic jack to the axle housing. Securely strap the jack to the housing.
5. Remove the components in the order indicated in the following illustration and table.

Part 1:

Part 2:

6. To install, reverse the removal procedure.
7. Fill the axle with the specified quantity of the specified lubricant.

Item 6: Pinion Nose Isolator Bushing Removal Note





1. Using the special tool, remove and discard the bushing.

Item 9: Rear Axle Assembly Isolator Bushing Removal Note
1. Using the special tool, draw the isolator from the frame pocket.

Item 9: Rear Axle Assembly Isolator Bushing Installation Note
1. Using the special tool, draw the isolator into the frame pocket.
^ Install the isolator with the rubber legs positioned vertically.

Item 6: Pinion Nose Isolator Bushing Installation Note





1. Insert the rear axle differential pinion nose isolator bushing and make sure the notches are aligned 45° from a forward and aft location.





2. Using the special tool, install the rear axle differential pinion nose isolator bushing.