Right Hand Side

Exhaust Manifold-RH

Removal and Installation
1. With the vehicle in NEUTRAL, position on a hoist.
2. Remove the RH lower splash shield.
3. Remove the components in the order indicated in the illustration and table.

Part 1 Of 2:

Part 2 Of 2:

4. To install, reverse the removal procedure.

Item 6: RH Exhaust Manifold Nuts Installation Note





1. NOTE: To verify the seal, the manifold bolts must be tightened to the same specification two times.

Tighten the exhaust manifold nuts in the sequence shown in two stages:
^ Stage 1: Tighten to 20 Nm (15 ft. lbs.).
^ Stage 2: Tighten to 20 Nm (15 ft. lbs.).