Left Hand Side

Exhaust Manifold-LH

Removal and Installation





1. With the vehicle in NEUTRAL, position on a hoist.
2. Remove the LH lower splash shield.
3. Remove the components in the order indicated in the illustration and table.
4. To install, reverse the removal procedure.

Item 5: LH Exhaust Manifold Nuts Installation Note





1. NOTE: To make sure of a seal, the manifold bolts must be tightened to the same specification two times.

Using a new gasket, install the exhaust manifold. Tighten the nuts in two stages.
^ Stage 1: Tighten to 20 Nm (15 ft. lbs.).
^ Stage 2: Tighten to 20 Nm (15 ft. lbs.).